ELT-22107 Laboratory of Electronics Device Design, 5-8 cr

Vastuuhenkilö

Jouko Heikkinen, Katja Laine, Mikko Valkama

Opetus

Osaamistavoitteet

After completing the New Electronics Materials and Manufacturing laboratory assignments the student is able to: - analyze the reliability and environmental aspects of electronic devices - demonstrate the operating principle of printed supercapacitors, measure the key phenomena of supercapacitors and draw conclusions of the measurement results - work in a cleanroom, demonstrate the inkjet printing of conductive materials, measure the key phenomena of printed electronics and draw conclusions of the measurement results - write scientific reports After completing the Equipment Engineering laboratory assignments the student is able to: - design, implement and test a linear DC power supply - program a FPGA device - measure radiated and conducted emissions of an electronic device - write scientific reports

Sisältö

Ohjeita opiskelijalle osaamisen tasojen saavuttamiseksi

The final grade of the course is determined based on the grades of the laboratory assignments. The grades of the laboratory assignments are weighted according to the credits of the assignment.

Arvosteluasteikko:

Numerical evaluation scale (0-5)

Osasuoritukset:

Completion parts must belong to the same implementation

Esitietovaatimukset

Tietoa esitietovaatimuksista
Above mentioned courses or previous equivalent knowledge from another university is required as a prerequisite. ELT-21251 (or equivalent knowledge) is required only if assignments related to Equipment Engineering are selected.

Vastaavuudet